Mix concrete resurfacer according to instructions on the bag.
Resurfacing concrete porch and steps.
You do not want to fill in your existing control joints so apply duct tape over them.
Concrete resurfacing using an overlay can make an old cracked and pitted concrete patio look like new again.
Using the same color and pattern for both unifies the look and creates a seamless transition to your front door.
That s enough to cover two sidewalk slabs or about 17 square feet.
Instructions for resurfacing a concrete patio wash the existing concrete surface with a power washer.
Start at one end of your concrete slab and work your way toward the other end.
A stamped concrete porch with matching steps make a dynamic duo.
Properly clean the surface and make necessary repairs as described on the bag.
See more ideas for a stamped concrete porch.
This patio i repaired the small cracks lightly ground the surface applied the overlay with a hand trowel at about 1 16 inch thick then dragged a broom across the overlay to give it a broomed finished look.
Unify your porch and steps with stamped concrete.
Very simple and inexpensive.
Fill the walkway joints with peel and stick foam weatherstripping and dampen the concrete if necessary.
Shape the edges of the steps and the corners where the steps.
The resurfacer is workable for about 20 minutes so mix just half a bag of powder with 5 cups of water at a time.
This step will help the new concrete adhere to the old surface.
Use concrete with at least 3 000 psi and good adhesion.
Pour it on the walk.
Section off work areas no larger than 144 square feet 13 4 square meters.
Find out how to repair and resurface old concrete steps so they look as good as new.
It s essential that control joints and expansion joints are maintained.
Brush the surface with a masonry brush or concrete finishing brush.
Add liquid a little bit at a time to a peanut butter consistency.
Lift your bucket and pour all of the mixed resurfacer onto your concrete in a strip that s 1 foot 0 30 m wide by 6 8 feet 1 8 2 4 m long.
Pour the resurfacer in a small area on top of your concrete.
Pouring a skim coat over the surface is exactly what your concrete needs.
Add a second coat as needed while the first coat is still wet to ensure that the concrete has a smooth finished.
If your patio driveway or other concrete slab is falling apart and losing its appeal then you need to give it a facelift.